Split mechanical keyboard with a 3D printed case (Corne)

foostan's Corne v4, a 42-key split keyboard: each half is a printed tray holding a hot-swap PCB, an FR4 switch plate and MX switches. The halves link with a TRRS cable and run QMK or Vial.

Each half 138 × 98 × 29 mm42 keys, Corne v4 PCBPLA, about 30 g per halfRoughly 1.5 h to print each half

Loading the model…

What you need

  • 2 × Corne Cherry v4 hot-swap PCBsa left and a right; ordered assembled, they come with the RP2040 controller, USB-C, TRRS jack, diodes and hot-swap sockets already on
  • 2 × FR4 switch plates, 1.6 mmfrom the plate Gerbers in the zip, or with a kit
  • 42 × MX-compatible switchesup to 46 if you also fill the two extra inner keys per half (then use the -ex plate)
  • 40 × 1u keycaps
  • 2 × 1.5u keycapsfor the innermost thumb keys
  • 8 × M2 spacers, 7.5 mm
  • 16 × M2 screws, 5 mm
  • 8 × Rubber feetabout 10 mm across
  • 1 × TRRS cable (4-pole)a 3-pole TRS cable also works on PCB v4.1
  • 1 × USB-C cable
  • PLA filamentabout 60 g

Tools

  • A 3D printer
  • A small screwdriver for the M2 screws
  • A switch puller, handy if a pin bends
  • A computer to flash the firmware

Files

Design: Corne keyboard (crkbd), Cherry v4 with the 3x6 case by foostan, under CC BY 4.0 / MIT. Converted the 3x6 case STEP files to STL in the assembled position and added simple stand-ins for the PCB, plate, switches, keycaps and hardware; the instructions are our own.